Great news we have a solution now that is automated and easy.
NinjaTrader has a limited number of “slots” for custom bar types and there is no way to know who is using which slot.
Sometimes our default slot, “Custom8”, will conflict with bars distributed by other vendors. Luckily, we have given you a way to move our bars to different slot. Please follow these instructions to change the slot used by our bars:
Note if you have not updated since 11 AM ET May 5 th 2014 then first run the install file so the setting will show up after you run the install file close it and run it again. So when it says install complete then run it again to see the setting for changing the custom bar type as shown below.
[LIST=1]
Note that if you change this setting, your custom saved workspaces won’t load properly until you have replaced them with new ones. Ideally, you will avoid changing it except in the case of a conflict of bar types.
Apex uses Custom 4, 7, 8, and 9 for various bar types we have.
(note clarity bar is in alpha and has a ways to go and is not available yet)
NinjaTrader gives a small number of “slots” for custom bar types.
We use the slot “Custom8” and 4 and 7 and 9 for our Diagnostic Bars. Sometimes it conflicts with bars provided by another vendor. When you have a conflicting bar type installed, NinjaTrader will only display one of them. Sometimes it blocks our bars; sometimes it blocks the bars from the other vendor. Just follow the steps above to resolve this.
The following use custom 8
- List item
- RJayTickRangeAdaptive
- WickedLineBreak
- Better Range BWT LineBreak
- PureLogic LineBreak
- SiTrueRenko Time Trade
- Diagnostic Bars
The following use custom 9
- OFA
- Shadow Bars